- [email protected]
- +91 9151118036
The RD V-Series 60A (Without Enclosure) is a Made in India trapezoidal electronic speed controller supplied as a bare board without wires, for integrators who build it into their own housing and cooling.
It runs on 4S to 12S LiPo packs with 30 A continuous and 60 A peak current with active cooling. These values are tentative. It accepts PWM and DShot300 input and reports telemetry.
| S. No. | Parameter | Requirement | Remark |
| 1 | Input Voltage | 4S-12S LiPo | – |
| 2 | Continuous Current | 30A* | With active cooling |
| 3 | Peak Current | 60A* | With active cooling |
| 4 | BEC Output Voltage | No | – |
| 5 | Operating Ambient Temperature | (-20℃) ~(+ 65℃) | – |
| 6 | Standby current (24V) | ≤ 36mA * | – |
| 7 | Throttle Range | 1050us ~ 1950us | – |
| 8 | Recommended Throttle refresh frequency | 50 Hz to 450 Hz | – |
| 9 | Throttle I/P mode | PWM and DShot300 | – |
| 10 | Over Temperature Protection | Yes | Limit at 100℃, Reduced to 50% throttle |
| 11 | Overcurrent Protection | Yes | – |
| 12 | Stuck Rotor Protection | Yes | – |
| 13 | Waterproof Rating | No | – |
| 14 | Invert Motor Spin | Yes | Configured using RD GUI |
| 15 | Telemetry | Yes | With PWM and D-Shot |
| 16 | Braking Feature | NA | TBT |
| 17 | Input cables | Silicone wires-red/black- 12 AWG | Wire not Soldered with ESC, Recommended 12 AWG at I/P |
| 18 | Output cables | Silicone wires-black(x3) – 14 AWG | Wire not Soldered with ESC, Recommended 14 AWG at O/P |
| 19 | Signal wires | Silicone wires – black , white(2P),red(1P) 3P-JR Connector | Wire not Soldered with ESC |
* Tentative values.